Ignition Switch Replacement; Handlebar Switch - Honda TRX450R Service Manual

LIGHTS/SWITCHES (After '05)
IGNITION SWITCH
INSPECTION
Remove the top cover (page 3-5).
Disconnect the ignition switch 4P black connector.
Check for continuity between the switch side con-
nector terminals in each switch position.
Continuity should exist between the color coded
wires as shown below:
^\Color
Position^\
OFF
ON
Black/
white
o-
Green
- 0
Red
o-
Black
- o
\
Route the ignition
switch wire
properly (page 1-
24).
REPLACEMENT
Remove the following:
- top cover (page 3-5)
- handlebar cover (page 24-5)
Remove the 4P (black) connector from the stay and
disconnect it.
Release the switch wire from the clips on the frame.
Remove the ignition switch from the handlebar
cover by pushing in the two stoppers.
Install a new ignition switch by aligning the locating
tab with the cover groove.
Install the removed parts in the reverse order of
removal.
IGNITION SWITCH
\ 1
STOPPERS
LOCATING TAB
HANDLEBAR SWITCH
INSPECTION
Remove the top cover (page 3-5).
TRX450ER: Remove the handlebar switch 6P natural connector
from the stay and disconnect it.
TRX450R: Remove the handlebar switch 4P natural connector
from the stay and disconnect it.
HANDLEBAR SWITCH 6P (TRX450ER)
or 4P (TRX450R) CONNECTOR
24-7