Honda TRX450R Service Manual page 390

REAR WHEEL/SUSPENSION
Install the snap ring into the bearing holder groove
with the "OUT SIDE" mark facing out.
SNAP RING
Install the driven sprocket with the four socket bolts,
washers and nuts, and tighten the nuts.
TORQUE: 59 N-m (6.0 kgf m, 43 Ibf-ft)
Coat a new O-ring with oil and install it between the
driven sprocket flange and axle.
Install the rear axle into the bearing holder through
the drive chain until it is fully seated.
Install the drive chain over the driven sprocket.
Install the drive chain guard with the collars and
new bolts, and tighten the bolts.
TORQUE: 9.8 N m (1.0 kgf m, 7 Ibf-ft)
Apply grease to the hub nut threads and seating
surface.
Install the left wheel hub and hub nut.
Install the left rear wheel with the tire valve facing
out.
Install the wheel nuts with the tapered side facing
inward and tighten them.
TORQUE: 64 N m (6.5 kgf m, 47 Ibf-ft)
Tighten the hub nut to the specified torque and fur-
ther tighten it until its grooves align with the cotter
pin hole.
TORQUE: 147 N m (15.0 kgf m, 108 Ibf-ft)
Install a new cotter pin.
TIRE VALVE
18-14