Removal Of The Lamp House - Barco HDQ 2K40 User Manual

Personal protection rules
• Handle the cooling liquid in a well ventilated room.
• Under no circumstances eat, drink and smoke while handling the liquid.
• Wear gloves (Butyl rubber, PVC....) and Goggles.
• Wear suitable protection clothing.
Order info cooling liquid
B1909086K: bottle of 1 liter cooling liquid.
How to top up the cooling liquid?
1. Remove the left projector cover. See "Removal of the left cover", page 312.
2. Open the reservoir. Remove the filler cap by turning it anti clockwise.
3. Fill the reservoir with cooling liquid until the level is equal with the Max indication on the reservoir.
4. Close the reservoir again. Install the filler cap by turning it clockwise.
Image 16-4
Refilling the cooling liquid reservoir
Caution: Tighten the filler cap sufficiently to avoid cooling liquid leakage. Tighten to a torque of 7 Nm.
5. Install the left projector cover. See "Removal of the left cover", page 312.
C
AUTION

16.7 Removal of the Lamp House

W
ARNING
W
ARNING
unplug the power cord at the UPS INLET for removal of all power from the projector.
R5905303 HDQ 2K40 02/03/2015
:
Never fill the cooling liquid reservoir above the Max level mark.
:
The procedure below may only be performed by "qualified service technicians".
:
Before removing the Lamp House, disconnect the power to the projector mains terminals and
16. Maintenance
303