Selecting And Changing The Position Of A Specific Point; Scaling The Image - Barco HDQ 2K40 User Manual

13.8.10 Selecting and changing the position of a specific point
About point selection
Depending on the warp level, number of selectable points, a specific point can be selected and moved in any direction. The coordi-
nate system works with 33 x 33 pixels (0 to 32). Depending on the warp level the cursor will jump from active point to active point.
E.g. for 5 x 5 the first point has coordinates (0,0), the second point in horizontal direction will have coordinates (12,0), etc. .
How to select a point
1. Select the warp level (1).
2
1
Image 13-46
Point selection
2. Select Warp mode points (2).
3. Use the ▲ or ▼ key to go to Point selection.
4. Select alternating the X and Y coordinate and change the value (3).
Or,
press ENTER to open the point selection window.
Use the 4 arrow keys to select the desired point.
Press ENTER to the Warping adaptations.
Image 13-47
Point selection
5. Use the 4 arrow keys to change the position of the selected point.

13.8.11 Scaling the image

About scaling
It is possible to scale the whole image. This is considered as an equal scale of the 4 corner points in 2 x 2 mode. The Warping
adaptation window is used to scale the image.
How to scale
1. Select the 2 x 2 adjustment level. See "Setting the warping level", page 185.
The default selected anchor point is the left top corner of the image.
2. Select the desired warp area.
R5905303 HDQ 2K40 02/03/2015
0 1 2 3 4 5 6 7 8 9 10
1 2
0
1
2
3
4
5
6
7
8 6 7
9
10
11
12
13
14
15
11 12
16
17
18
19
20
21
22
23
24
16 17
25
3
26
27
28
29
30
31
32
21 22
Image 13-48
Moving selected point
11 12 13 14 15 16 17 18 19 20 21 22 23 24
3 4
8 9
13 14
18 19
23 24
13. Alignment
25 26 27 28 29 30 31 32
5
10
15
20
25
189