a) Push the safety hook through the loop of the safety cable and wrap the bottom frame.
b) Mount the other end of the safety cable around the upper frame and clasp the safety hook around the cable as illustrated.
Make sure that the falling distance is maximum 20 cm (8"). If necessary, before clasping the safety hook around the cable,
turn the cable a few time around the frame.
c) Repeat this procedure for the other safety cable on the other side of the frame.
Image 3-23
3.9
Adjusting the multifunctional frame
Introduction
The Barco HDQ 2K40 is mounted by default in a multifunctional frame. This frame can be used to adjust the projector position. The
frame can be adjusted in 3 different ways:
•
inclinating
•
rotating
•
skewing
The image below explains these 3 terms.
A
Image 3-24
R5905303 HDQ 2K40 02/03/2015
2x 2x
B
3. Physical installation
C
37