Rcu Rugged Case Installation - Barco HDQ 2K40 User Manual

3. Physical installation
How to install the batteries in the remote control ?
1. Push the battery cover tab with the fingernail a little backwards (1) and pull, at the same time, the cover upwards (2).
Image 3-2
2. Insert the two AA size batteries, making sure the polarities match the + and - marks inside the battery compartment.
Image 3-3
3. Insert (1) the lower tab of the battery cover in the gap at the bottom of the remote control, and press (2) the cover until it clicks
in place.
2
Image 3-4
C
AUTION
battery is replaced with an incorrect type.
C
AUTION
installed.
3.1.2

RCU rugged case installation

How to install the rugged case of the remote control ?
1. Slide the bottom of the RCU into the rugged case and then pull the top of the rugged case over the top of the RCU as illustrated.
24
1
1
:
Replace with the correct battery type. Use two AA size batteries. There is a risk of explosion if the
:
Replace the battery as explained above. There is a risk of explosion if the battery is incorrectly
2
R5905303 HDQ 2K40 02/03/2015