Removal Of The Lamp House - Barco DP2K-12C Service Manual

6. Lamps and lamp houses
6.2

Removal of the lamp house

W
ARNING
C
AUTION
minutes before proceeding to the lamp unit replacement.
C
AUTION
handled.
Necessary tools
• Flat screw driver or
• Nut driver 8 mm
How to remove the lamp house of the projector
1. Switch off the projector.
2. Remove the lamp cover.
3. Release the three spring lock screws of the lamp house as illustrated.
Image 6-4
Release lamp house
4. Take the lamp house by the handles and pull it out of the projector.
Caution: Be aware of the weight of the lamp assembly. Take the necessary precautions to avoid personal injury.
96
:
This procedure may only be performed by qualified technical service personnel.
:
Lamp casing is very hot after operation. To avoid burns, let the projector cool down for at least 15
:
Due to its high internal pressure, the lamp may explode in either hot or cold states if improperly
R5905043 DP2K-12C/11CX 19/02/2018