17. REMOVAL AND INSTALLATION OF THE PROJECTOR
COVERS
W
ARNING
W
ARNING
unless otherwise mentioned in the procedure.
Overview
•
Removal of the lamp cover
•
Installation of the lamp cover
•
Removal of the input cover
•
Installation of the input cover
•
Removal of the front cover
•
Installation of the front cover
•
Removal of the back cover
•
Installation of the back cover
•
Removal of the left cover
•
Installation of the left cover
Location of the covers
The image below shows the location of the projector covers. Each cover can be removed individually.
4
1
Image 17-1
Location of the covers
1
Lamp cover
2
Input cover
3
Front cover
4
Back cover
5
Left cover
17.1 Removal of the lamp cover
Necessary tools
Flat screwdriver
How to remove the lamp cover?
1. Release the 2 captive screws (1).
2. Release the 2 locks by sliding them towards each other (2). Pull the bottom side away from the projector.
3. Remove the cover (3).
R5905303 HDQ 2K40 02/03/2015
:
All procedures in this chapter may only be performed by "qualified service technicians" .
:
Disconnect the power to the projector mains terminals and unplug the power cord at UPS INLET,
2
17. Removal and installation of the projector covers
3
5
307