Dmx; Dmx Address - Barco HDQ 2K40 User Manual

14. Projector Control
Image 14-58
Main menu, projector control
Image 14-60
IR control
2. Use the ▲ or ▼ key to select the desired IR control and press ENTER to check checkbox.
Checked : IR receiver is enabled and can receive and process commands sent by the remote control.
Not checked : IR receiver is disabled and not receive any command.

14.7 DMX

Overview
•

DMX address

• DMX universe
• DMX mode
• Art-Net DMX
• Front XLR output voltage control
• Monitor
• DMX Shutdown
• DMX Shutdown retarding time
About the ways to control the projector via DMX
With a standard DMX cable equipped with XLR connector DMX signals can be connected to the DMX In port on the communicator
interface. The DMX out can be used to create a chain of DMX devices. One universe can control up to 512 channels.
If you are using a DMX console and other automated lighting products compatible with Art-Net, the Ethernet network can serve as
the link for DMX control. All DMX controls can be sent over the Ethernet cable. Multiple universes are possible.
14.7.1 DMX address
What should be done ?
Before a projector can execute DMX commands, a unique address, called DMX address, should be given to the projector. This
address can vary from 1 to 512.
248
Image 14-59
Projector control, IR control
R5905303 HDQ 2K40 02/03/2015