Air Inlets And Outlets - Barco HDQ 2K40 User Manual

2. General
• Safety manual
• Quick start guide
• Warranty card
• CD-ROM with electronic version of the manuals
• Remote Control Unit (RCU)
• 2 AA size batteries for the RCU
• Data cable (DVI-A to RGB HV)
Mechanical check
This check should confirm that there are no broken knobs or connectors, that the cabinet and panel surfaces are free of dents and
scratches, and that the operating panel is not scratched or cracked. The Barco Sales and Service office should be notified as soon
as possible if this is not the case.
2.4

Air inlets and outlets

Air inlets and outlets
Image 2-6
The HDQ 2K40 projector has 3 air inlets (1 at the front and 2 at the bottom) and 2 air outlets (on the exhaust box on top of the
projector).
W
ARNING
why the floor covering can become very hot and must be resistant to a temperature of 90 °C (194 °F).
W
ARNING
would be monthly-minimum). Neglecting this could result in disrupting the air flow inside the projector, caus-
ing overheating. Overheating may lead to the projector shutting down during operation. See "Cleaning the
front dust filter", page 299 and "Cleaning the bottom dust filters", page 300.
W
ARNING
mum 20 cm (8") to ensure sufficient air flow. Loose papers or other objects may not be nearer to the projector
than 10 cm (4") on any side.
The projector must always be installed in a manner which ensures unimpeded evacuation of the hot air from
its cooling system.
The projector should be used in an area where the ambient temperature, as measured at the projector air inlet,
does not exceed +35°C (+95°F).
20
:
When the projector is used in portrait mode, the air outlet is positioned towards the floor. That's
:
The air filters of the projector must be cleaned or replaced on a regular basis (a "clean" booth
:
The projector is fan cooled and must be installed with sufficient space around the air inlets, mini-
R5905303 HDQ 2K40 02/03/2015