Switching To Standby; Switch Off The Projector; Status Leds - Barco HDQ 2K40 User Manual

6. Getting started
6.4

Switching to standby

How to switch to standby
1. Press and hold Standby for 3 seconds on the local keypad or the remote control. In the mean time the message Keep on
pressing... is displayed. This message changes to Saving data ...
The projector goes to standby.
All custom settings are written to the internal backup device. A message 'Saving data ...' indicates this
process. Never switch off the projector while this message is displayed.
When switching to standby, an after cooling process will start to cool down the projector. The after cool time
depends on the temperature inside the projector and can vary from 30 second to 5 minutes.
6.5

Switch off the projector

How to switch off the projector?
1. Press first Standby.
2. Let the projector cool down until the fan speed decreases. At least 5 minutes.
3. Switch off the projector with the power switch. '0' must be pressed.
C
AUTION
6.6

Status LEDs

Overview
LED Color status
Standby button Red on
Red toggles on/off
Green toggles on/off
Green on
White toggles on/off
Dimmed white
Orange toggles on/off Lamp power supply failed
Pause button Red on
Green on
Dimmed white
Full white
Full white toggles
on/off
PWR (power Off
LED)
Red
Orange
Green
70
:
Never switch off the projector while the message 'Saving data ... ' is displayed !
Description
Projector is in standby
Projector startup failed, no lamp power supply
Projector starts up
Projector is on
From/To ECO standby
Projector powers up
Shutter is closed
Shutter is open
Shutter is closed, projector in standby
Shutter is undefined (shutter not open and not closed)
Shutter is closed during reset formatter
Projector powers up
Standby
ECO standby
Projector is on
R5905303 HDQ 2K40 02/03/2015