Barco HDQ series Quick Start Manuals

Local LCD screens
A A
1 2
Overview window Lamp overview window
(A)
• •
Main source Number of strikes
• •
PiP source Run time (hours)
• •
IP address Remaining run time (hours)
• •
Customer ID % lamp used
•
Lamp status
•
Mains voltage
•
Ambient temperature
•
Text status (OSD)
Menu structure
INPUT IMAGE
Slot Module Type Image Settings
Input Locking Aspect Ratio
Native Resolution Timings
No Signal Image File Services
EDID Save Custom Settings
3D* Splash image
ALIGNMENT PROjECTOR CONTROL
Orientation Projector Address
Lens Serial communication
Warping Network
Blanking IR control
DMX
Contrast/Intensity
Gamma Buttons
Internal patterns Menu Position
Color Space Local LCD
ScenergiX Change Language
Scheduler
* Only available with optional 3D input
HDQ-Quickstartguide4.indd 1
B
1 1
2
About window
(B) (C)
•
Package version in use
•
Mgr Software in use
•
GUI Software in use
Common parts
•
Error and warning area (1)
•
Projector status (2)
Green: projector works correctly
Red cross: projector has errors
Yellow triangle: projector has warnings
LAyOUT LAMPS
Main Window Lamp Power
PiP Window Identification
Z-axis
Layout File Services
Same Zoom/Focus
SERvICE
Identification
Diagnostics
Int. Service Patterns
Factory Default
USB Memory
Reset Formatter
Refill mode
Save Custom Settings
Auto Dim overtemp.
Time and Date
Support
www.barco.com/esupport
USA +1 866 374 7878
EMEA +32 56 368019
APAC +86 400 88 22726
R5905324 Rev. 01
HDQ series Quick start guide
Mounting the lens
C
B
2
A
•
Remove foam in lens opening.
•
Place lens holder in unlock position. Handle A
towards socket B.
•
Gently insert the lens in such a way that the
lens connector matches the socket B.
Additional vertical shift
1
2
Mounting the lamp house
1
2
1
Before installing the Lamp House, dis-
connect the power to the projector
mains terminals and unplug the power
cord at the UPS INLET for removal of all
power from the projector
1
• •
Insert the lens until the connector seats into Check if lens touches the front plate of the
the socket. lens holder.
•
Secure the lens in the lens holder. Move •
Check if the lens is really secured by trying to
handle A into the lock position (away from
pull the lens out of the lens holder.
•
socket B). Place the 2 lens fixation brackets (1) into po-
sition and secure with a nut on each bracket
•
To extend lens shift in a specific direction.
•
Loosen the 4 screws (1) until central part of
lens holder becomes loose.
•
Shift the central part up or down.
•
Lowermost, middle and uppermost shift posi-
tions are marked on the lens holder (2).
•
Tighten the 4 screws.
2
3
1
• •
Remove housing on lamp house side. Push the lamp house fully in.
• •
Grip the lamp house by both handles (1) Secure both retaining screws.
• •
Place the lamp house on the base plate inside Mount the housing
the lamp compartment.
•
Line up the foot of the lamp house with the
slots on the base (2).
1
9-11-2012 14:22:37