Stacking Multiple Projectors - Barco HDQ 2K40 User Manual

3.8

Stacking multiple projectors

Introduction
The Barco HDQ 2K40 is mounted by default in a multifunctional frame. This frame can be used to stack multiple projectors onto
each other. The stacked projectors can be used in a standing (table mount) or hanging configuration (ceiling mount).
W
ARNING
stack more than two (2) projectors in a hanging configuration (ceiling mount). Failure to do so can cause
serious injury or death.
W
ARNING
W
ARNING
estimate the weight of the projector. The projector weights ±220 kg (±485 lb.).
W
ARNING
the projector. The clamps must be fixed to the projector frame. Use a truss which is capable of handling five
(5) times the complete load of the system.
W
ARNING
frame and the truss.
When a dual stacking configuration is suspended from a truss, always mount 2 extra safety cables around
both projector frames. See the procedure below for the correct use of these cables.
Allowed configurations
The illustrations below show which configurations are allowed. All other stacking configurations are not allowed.
Image 3-20
Allowed configurations - table mount
R5905303 HDQ 2K40 02/03/2015
:
Never stack more than three (3) projectors in a standing configuration (table mount) and never
:
It is not allowed to stack multiple projectors in portrait mode.
:
It is forbidden to lift up the projector with manpower, use a hoisting tool instead. Do not under-
:
When the projector is suspended from a truss, minimum four (4) clamps must be used to secure
:
When the projector is suspended from a truss, always mount 2 safety cables around the projector
3. Physical installation
35