3. 10 Status Menu - Christie Mirage S+14K User Manual

OPERATION
How Old is the Lamp?
When to Replace
the Lamp

3. 10 Status Menu

3-52
Roadster / Mirage S+ User's Manual
Downloaded From projector-manual.com Christie Manuals
will reset to "0". Lamp Mode and Lamp Limit remain as they were for the previous
lamp and can be changed at any time.
Figure 3.26. Recording the New Lamp Serial Number
NOTE: Enter a serial number only if you have just installed a new lamp. This will
help ensure that lamp timer is not reset on an old lamp and that the number of hours
logged on the lamp will be accurate.
ALWAYS record the serial number of a NEW lamp.
'
When a new lamp is installed and its
serial number recorded by selecting
"Change Lamp" in the Lamp menu, the
lamp timer resets to "0" and begins
logging time for the new lamp. This
tally appears in both the Lamp menu
(see right) and the Status menu.
To review the number of hours logged
for previous lamps, consult the Lamp
History menu.
'
If the "Lamp Message" checkbox has
been enabled in the Lamp menu (recommended), an expiry message will appear upon
power-up when the lamp has reached its defined "Lamp Limit". The lamp should be
replaced.
The "Lamp Limit" setting should not exceed the warrantied lamp lifetime, as an old
lamp becomes increasingly fragile and more prone to sudden failure.
See also 4.4, Replacing the Lamp & Filter and Section 6, Specifications.
The read-only Status menu lists a variety of details about the standard and optional
components currently detected in the projector. Refer to the Status menu for versions
of hardware and software installed, the type (size) of lamp defined in projector
memory, and hours logged in total and for a specific period (such as a rental period),
and for your projector model name and serial number. In addition, the Status menu
identifies the current channel, its location, its frequencies and other details.
Scroll the full Status menu using
IMPORTANT
. Use for page up/down.