Honda 2004 Odyssey Service Manual page 2070

7. Remove the center pillar lower trim panel (see page
20-58).
8. Remove the upper anchor bolt (A).
A
7/16-20 UNF
32 N·m
(3.3 kgf·m, 24 lbf·ft)
E
C
6 x 1.0 mm
4 N·m
(0.4 kgf·m, 3 lbf·ft)
'03-04 models passenger's seat belt
B
F
9. Disconnect the seat belt tensioner connector (B).
Remove the retractor mounting ET screw (C), and
for '03-04 models passenger's seat belt, remove the
retractor bolt (D), then remove the front seat belt (E)
and retractor (F).
10. If necessary, remove the front seat belt protector
(G).
B
G
F
G
E
C
6 x 1.0 mm
4 N·m
(0.4 kgf·m,
3 lbf·ft)
D
7/16-20 UNF
32 N·m
(3.3 kgf·m, 24 lbf·ft)
11. Remove the center pillar upper trim (see page 20-
58).
12. Remove the shoulder anchor adjuster (A).
A
13. Install the seat belt and retractor in the reverse
order of removal, and note these items:
• Apply liquid thread lock to the anchor bolts
before reinstallation.
• Check that the retractor locking mechanism
functions (see page 23-15).
• Assemble the washers, collar and bushing on the
upper and lower anchor bolts as shown.
• If the seat belt tensioner has been activated,
replace the front seat belt protector with a new
one.
• Before installing the anchor bolts, make sure
there are no twists or kinks in the seat belt.
• Make sure the seat belt tensioner connector is
plugged in properly.
• Reconnect the negative cable to the battery.
• Enter the anti-theft code for the radio and the
navigation system, and then enter the customer's
radio station presets.
• Reset the clock.
• Do the PCM idle learn procedure (see page 11-
202) and the power window control unit reset
procedure ('03-04 models) (see page 22-200).
8 x 1.25 mm
22 N·m (2.2 kgf·m,
16 lbf·ft)
(cont'd)
23-5