Forced Starting Of Display; Dvd-Rom Replacement - Honda 2004 Odyssey Service Manual

Forced Starting of Display

Special Tools Required
SCS service connector 07PAZ-0010100
1. Locate the navigation service check connector (A)
under the front passenger's seat.
B
07PAZ-0010100
2. Connect the SCS service connector (B) to the
navigation service check conector (A).
3. Check that the diagnosis menu for the picture
diagnosis starts up, and then changes to the
system link menu.
4. If the display does not turn on, turn the ignition
switch OFF, press and hold the SET UP button (A),
press and hold the joystick (B) up, then turn ignition
switch to ACC (I).
NOTE: If the display fails to light or the system link
screen is not displayed, refer to no picture is shown
on the display (see page 22-366).
A
A
B

DVD-ROM Replacement

NOTE: When the DVD-ROM is re-inserted or replaced, a
map match must be done (see page 22-351).
1. Turn the ignition switch ON (II).
2. Open the front cover (A) of navigation unit.
A
3. Press the EJECT (B) switch.
4. Remove the DVD-ROM.
5. Insert the new DVD-ROM.
6. Close the front cover.
NOTE: After servicing, the front cover must be
closed. If you start up the navigation system with
the front cover open, the display will indicate.
''Navigation unit door is open or No DVD Disk
installed. Please check system.''
Do not turn the ignition switch OFF, until data is
down loaded to navigation unit.
7. Perform After Servicing Procedures (see page 22-
351).
B
22-383 22-383