System Diagnosis Test - Honda 2004 Odyssey Service Manual

Navigation System

System Diagnosis Test

Start-up procedure
1. Turn the ignition switch ON (II), select ''OK'' on the
Disclaimer screen then press and hold the buttons
in this order: (1) MENU button. (2) MAP/GUIDE
button, (3) CANCEL button, and keep them pressed
for 5 seconds.
2. After the display changes to the diagnosis menu
screen, select the item you want to check, and the
check will start. To return to the previous screen,
select the ''RETURN'' on the screen.
• System Links.
• Tire Calibrate.
• Monitor Check.
• Yaw Rate.
• Unit Check.
• Cyclic Diag.
• Rear camera. ('03-04 Models Only)
• In-line Diag.
DIAGNOSIS MENU SCREEN
Diagnosis Menu
System Links
Monitor Check
Unit Check
Rear Camera
In-Line Diag
22-376
Return
Tire-Calibrate
Yaw Rate
Cyclic Diag
'03-04 Models Only
System Links
• During diagnosis, all of the communication lines
connecting the components are shown in yellow.
• If the system is OK, all of the communication lines
connecting the components will change to green, the
screen will indicate ''OK'', and a tone will sound.
• If there is a problem in the system, the faulty
communication line will change to red, the screen
will indicate ''NG'', and a tone will sound.
NOTE: If the A/C link is red, refer to climate control
manual switch troubleshooting (see page 21-116).
• The indication on the screen will not change until the
ignition switch is cycled. After repairing the system,
turn the ignition switch OFF to reset the system, then
return to the Diagnosis Menu screen, and run system
Links again.
System Links
Disp
A/C
Tire Calibrate
• The ''AUTO TUNING'' is factory-set to ''ON'', and it
should remain on. If you find it has been turned OFF,
turn it back ON.
• The ''TIRE-CAL TUNING'' should not be used. The
AUTO TUNING function keeps the system in better
tune.
Tire-Calibrate
Tire-Cal Factor
Auto-Tuning
Tire-Cal Tuning
STD
OK Rerutn
ANT
GPS
Navi ECU
Return
7.0%
ON
7.0%
Set