Snmp Context; Enable - Symbol WS5000 Series System Reference Manual

8-258
WS 5000 Series System Reference

8.49 SNMP Context

The Wireless 5000 Series Switch supports Simple Network Management Protocol (SNMP) version 1 ,SNMP
v2 and SNMP v3. The switch supports SNMPv1 and SNMPv2 traps.
Use the CLI context to configure the SNMP trap destinations, the SNMP clients as well as the SNMP
SNMP
agent status. There are two sub-contexts where in the SNMP can be configured.
• SNMP v2 ( context)
v2
• SNMP v3 ( context)
v3
Note No special configuration for V1 access is required, it can be done with v2
communities.
The SNMP context provides commands that configures the SNMP system and that controls the activity of the
SNMP daemon.
Table 8.54 summarizes the commands within this context. Common commands between multiple contexts are
described in further detail in the
Table 8.54 SNMP Context Command Summary
Command
.. or end Terminate a current session and moves up a context, hierarchically.
exit Terminate a current session and returns to the "root" prompt.
? or help Get the command information.
logout or bye Close this session.
clear Clear the screen.
emergencymode Enable or disable Emergency mode.
Starts the SNMP daemon.

enable

Stops the SNMP daemon.
disable
Remove an SNMP trap destination.
remove
set Enable/Disable KDC config through SNMP, and Enable/Disable SNMP traps,
Configure SNMP trap destinations.
Shows details pertaining to the SNMP sub-system.
show
v2 Configure SNMP v2 access parameters
v3 Configure SNMP v3 access parameters
8.49.1 enable
SNMP Context
Starts the SNMP daemon.
Common Commands section.
Description Ref.
page 8-7
page 8-7
page 8-7
page 8-8
page 8-8
page 8-8
page 8-258
page 8-259
page 8-259
page 8-260
page 8-262
page 8-263
page 8-263