Snmp Context; Enable - Symbol WS5000 Series System Reference Manual

8-192
WS5000 Series Switch System Reference Guide

8.43 SNMP Context

The SNMP context provides commands that configure the SNMP system and that control the activity of the
SNMP daemon.
Table 8.47 summarizes the commands within this context. Common commands between multiple contexts are
described in further detail in the
Table 8.47 SNMP Context Command Summary
Command
.. or end Terminate a current session and moves up a context, hierarchically.
exit Terminate a current session and returns to the "root" prompt.
? or help Get the command information.
logout or bye Close this session.
clear Clear the screen.
emergencymode Enable or disable Emergency mode.
Starts the SNMP daemon.

enable

Stops the SNMP daemon.
disable
Removes permissions (read only or read/write) for an SNMP client.
remove
Allows or disallows the configuration of the on-board Kerberos KDC
set kdcConfig
through SNMP.
Allows or disallows SNMP traps.
set snmpTrap
Identifies a remote host to which this switch will send SNMP traps.
set trapHost
set client
Shows SNMP details.
show
8.43.1 enable
SNMP Context
Starts the SNMP daemon.
Syntax
enable
Parameters
None.
Example
WS5000.(Cfg).SNMP> enable
Enabling...
Status : Success.
SNMP details:
-------------
SNMP (deamon) Status
Common Commands section.
Description
: Enabled
Ref.
page 8-5
page 8-5
page 8-6
page 8-6
page 8-7
page 8-7
page 8-192
page 8-193
page 8-193
page 8-194
page 8-194
page 8-195
page 8-196