Setthresholds; Shell - Symbol WS5000 Series System Reference Manual

9-22
WS5000 Series Switch System Reference
Example
SM-WS5000> save config TestConfig
Saving running configuration in: TestConfig.cfg
Saving wireless network management configuration...
Configuration saved successfully.
SM-WS5000>

9.2.31 setThresholds

This command is used to set/clear thresholds for monitoring.Whenever any of the cpu/mem/disk usage goes
above the specified threshold percent value, an alert is sent. As long as the usage remains above this
threshold, no more alerts are sent. When the usage goes down and subsequently, this threshold is crossed, an
alert will be sent again, and so on.
Please enable monitoring using 'set monitor' command before using this command.
Specify zero value to disable corresponding threshold monitoring.
Syntax
setThresholds [-c <nn>] [-m <nn>] [-d <nn>]
Parameters
-c <nn> Add syslog when cpu usage percent goes above <nn>.
-d <nn> Add syslog when disk usage percent goes above <nn>.
-m <nn> Add syslog when memory usage percent goes above <nn>.
Example
SM-WS5000> setThresholds -c 95
Various thresholds are now:
CPU Usage : 95%
Memory Usage : Monitoring disabled
Disk Usage : Monitoring disabled
SM-WS5000>

9.2.32 shell

This command is used to enter into the embedded OS Command prompt and environment.
Syntax
shell
Parameters
None
Alert Sent: No