Symbol WS5000 Series System Reference Manual page 63

Note If you do not wish to upgrade the firmware, use the following CLI command:
launch -c /image/PreUpgradeScript upgrade nofwcheck
6. Run the following command:
SM-WS5000> launch -c /image/PreUpgradeScript upgrade
The following details are displayed on your monitor. Enter WS5000_v2.1.0.0-xxxx.sys.kdi
as image name when the procedure prompts you to - "Enter the image
name".
SM-WS5000> launch -c /image/PreUpgradeScript upgrade
Verifying dominfo Checksum
dominfo Checksum Verification Passed
checking type of DOM
Showing details of DOM
Model Number______________________: Kouwell DOM
Serial Number_____________________: HyFlash
Controller Revision Number________: 14/05/02
Able to do Double Word Transfer___: No
Controller buffer size (bytes)____: 512
Transfer Speed____________________: > 10 Mbit/sec
Drive Type________________________: Removable
IORDY Supported___________________: No
Can IORDY be disabled by device___: No
LBA Mode supported________________: Yes
DMA Supported_____________________: No
Number of ECC bytes transferred___: 4
Number of sectors per interrupt___: 1
Number of Cylinders_______________: 980
Number of Heads___________________: 16
Number of Sectors per Track_______: 32
This is a Kouwell DOM which needs to be checked for the version of
DOM firmware
Checking DOM firmware
Verifying vdate Checksum
vdate Checksum Verification Passed
Current Firmware Version
Version Date: 040928b9
Dom Firmware up to date - Done
Enter the Image Name: WS5000_v2.1.0.0-xxxR.sys.kdi
Verifying Image Checksum
Image Checksum Verification Passed
Saving the Configuration before upgrading
2-11
Installing the System Image
00003768