Ethernet Policy Instance; Add - Symbol WS5000 Series System Reference Manual

8.30 Ethernet Policy Instance

An Ethernet policy instance configures the two Ethernet ports to support the LAN and the WLAN, and creates
and maps VLANs to the two ports.
Table 8.35 summarizes the commands within this context. Common commands between multiple contexts are
described in further detail in the
Table 8.35 Ethernet Policy Instance Context Command Summary
Command
.. or end Terminate a current session and moves up a context, hierarchically.
exit Terminate a current session and returns to the "root" prompt.
? or help Get the command information.
logout or bye Close this session.

add

Create and adds a VLAN to this ethernet policy instance.
add tunnel Create and add an existing GRE Tunnel to this ethernet policy instance.
clear Clear the screen.
description Set the description text.
emergencymode Enable or disable emergency mode.
remove Remove a VLAN from this ethernet policy instance.
remove tunnel Remove the GRE tunnel from this ethernet policy instance.
Configure attributes of the ethernet policy instance.
set
Display details about the ethernet policy instance.
show
tunnel Select a tunnel to configure.
Select a VLAN to configure.
vlan
8.30.1 add
Ethernet Policy Instance
Creates and adds a VLAN to this Ethernet Policy instance.
Syntax
add <vlan_ID> <NIC>
Parameters
vlan_ID The number that's assigned to this VLAN. Valid VLAN ID numbers are in the range [1-4095].
NIC The NIC that will support this VLAN.
Example
WS5000.(Cfg).EtherPolicy.[LabEtherPolicy]> add 200 1
Common Commands section.
Description
8-181
CLI Command Reference
Ref.
page 8-7
page 8-7
page 8-7
page 8-8
page 8-181
page 8-182
page 8-8
page 8-15
page 8-8
page 8-182
page 8-183
page 8-183
page 8-184
page 8-185
page 8-185