Symbol WS5000 Series System Reference Manual page 303

Table 8.6 set command's display_parameter Summary
Display Parameter
set emergencypolicy Set the Emergency Switch Policy
set autoinstall Enable/Disable auto-install
set rfstats Enables/Disables RF Stats gathering
set licensekey Update the port license
set location Set the switch location string
set muidletimeout Set the MU Idle Timeout value (for all MU's)
set rfthreshold Set RF Stats threshold values for SNMP traps
set logout Set CLI auto session logout time
set snmptrap Enable/disable SNMP traps (global flag)
set vpnsupport Enable VPN support
set switchpolicy Activate a Switch Policy
set time Set system time and/or date
set zone Set the time zone
set clearstat Clears Packet Stats
set arpcache
Configuration (Cfg) Context
Sets the address resolution display and control. The arp program displays and modifies the Internet-to-
Ethernet with no flags, the program displays the current ARP entry for hostname. The host may be specified
by name or by number, using Internet dot notation.
Syntax
set arpcache <command> <parameters>NAME
Parameters
hostname
-a The program displays all of the current ARP entries.
-d hostname A super-user may delete an entry for the host called hostname with the -d flag.
-s hostname ether_addr Create an ARP entry for the host called hostname with the Ethernet address ether_addr.
[temp] [pub] [trail] The Ethernet address is given as six hex bytes separated by colons. The entry will be
permanent unless the word temp is given in the command. If the word pub is given, the
entry will be 'published'; i.e., this system will act as an ARP server, responding to
requests for hostname even though the host address is not its own. The word trail
indicates that trailer encapsulations may
be sent to this host.
CLI Command Reference
Description
8-71
Example
page 8-72
page 8-73
page 8-73
page 8-74
page 8-75
page 8-75
page 8-76
page 8-77
page 8-77
page 8-78
page 8-78
page 8-79
page 8-80
page 8-81