Symbol WS5000 Series System Reference Manual page 310

8-78
WS 5000 Series System Reference
Parameters
snmptrap_flag Indicates whether to enable or disable SNMP traps on the switch. Possible values are:
• enable
• disable
Example
WS5000.(Cfg)> set snmptrap enable
Setting SNMP Trap status....
Status: Success.
SNMP details:
-------------
SNMP (deamon) Status
SNMP Traps
WS5000.(Cfg)> set snmptrap disable
Setting SNMP Trap status....
Status: Success.
SNMP details:
-------------
SNMP (deamon) Status
SNMP Traps
WS5000.(Cfg)>
set vpnsupport
Configuration (Cfg) Context
Used to enable or disable the VPN support.
Syntax
set vpnsupport enable|disable <license file>
Parameters
Use this to enables the VPN support.
enable
disable Use this to disables the VPN support.
license_file Use this to enter the location for the VPN license file.
Example
WS5000.(Cfg)> set vpnsupport enable
This command will reset the system.
Are you sure (yes/no) : y
Setting VPN Support status....
Status: Need minimum 256MB ram to enable vpn support !
WS5000.(Cfg)>
set switchpolicy
Configuration (Cfg) Context
Sets a defined switch policy to be designated as the active switch policy.
: Enabled
: Enabled
: Enabled
: Disabled