Getcclogfile; Install - Symbol WS5000 Series System Reference Manual

Syntax
ftpPasswd
Parameters
None
Example
SM-WS5000> ftpPasswd
Enter new UNIX password:
Retype new UNIX password:
passwd: password updated successfully
Password for FTP operations updated
SM-WS5000>

9.2.19 getcclogfile

This command is used to upload the CC log file to the TFTP server.
Syntax
getcclogfile
Parameters
None
Example
SM-WS5000> getcclogfile
Enter IP Address of TFTP Server where log file to be copied:192.168.168.10
File: CCErrors.txt copied successfully to 192.168.168.10
Do you want to disable Switch debug logging (yes/no)
Disabled Switch Debug Logging successfully.
SM-WS5000>

9.2.20 install

Configures the switch as primary or standby, installs Kerberos settings, or runs a CLI command file, depending
on the value of the first parameter.
Syntax
install <install_option> [file_name]
Parameters
Specify Primary or Standby to configure the switch as the primary or standby
install_option
Switch.Specify which command (.sym) file to install. Omitting a specific
command file, forces the system to install the default command *.sym file. If no
default command file exits, omitting the file name results in no changes to the
current configuration.
The optional command file name extensions are (.sym) or Kerberos file (.krb) to
file_name
install. Specifying a valid command file (*.sym) causes the switch to shutdown
and reset. Specifying a valid Kerberos file to update (*.krb) does not require the
Kerberos enabled switches to reset.
9-15
Service Mode CLI
: y