Network Policy Instance; Set - Symbol WS5000 Series System Reference Manual

8.40 Network Policy Instance

Table 8.45 summarizes the commands within this context. Common commands between multiple contexts are
described in further detail in the
Table 8.45 Network Policy Instance Context Command Summary
Command
.. or end Terminate a current session and moves up a context, hierarchically.
exit Terminate a current session and returns to the "root" prompt.
? or help Get the command information.
logout or bye Close this session.
clear Clear the screen.
emergencymode Enable or disable Emergency mode.
show Display available classifier instance details.

8.40.1 set

Network Policy Instance
Sets an attribute of this Network Policy instance.
Syntax
set <attribute> <value>
Parameters
attribute value
name name
inboundPolicy | remove
name
outboundPolicy | remove
name
Example
WS5000.(Cfg).NP.[NY_NetworkPolicy]> set
config_parameter is a required parameter.
set:
Use set to configure a Network Policy components.
Syntax: set <config_parameter>, <parameter_value>
where:
config_parameter
parameter_value
config_parameter:
name
Common Commands section.
Description
Sets the name of the Network Policy. Enter the name after the "name" attribute.
Adds the named Policy Object as the inbound policy. If the value is
policy is removed.
Adds the named Policy Object as the outbound policy. If the value is
policy is removed.
Network Policy parameter to be cofigured.
Value for the NP parameter.
Type 'remove' to remove a Policy Object
Change name of the Network Policy.
CLI Command Reference
Description
8-225
Ref.
page 8-7
page 8-7
page 8-7
page 8-8
page 8-8
page 8-8
remove , the
remove
, the