Authenticate - Symbol WS5000 Series System Reference Manual

name Name given to the user or slave KDC.
domain Domain of the slave KDC.
IP_address IP address of the Slave KDC
domain Domain of the Slave KDC.
Example
WS5000.(Cfg).KDC> add
Enter password for the mu "symbol"
Confirm password for mu "symbol"
Adding mu 'symbol' to the KDC.
Status: Success.
List of active MUs (KDC user):
Type Name
---- ----
MU symbol
WS5000.(Cfg).KDC>

8.38.2 authenticate

KDC Context
Authenticates a slave KDC with its master. This is used when a KDC master has been deleted and re-created
afterwards. In this case, the slave has no way of knowing if a new master has been configured, therefore it
needs to be manually authenticated again.
Note When you try to exectue this command on a switch which has been confiured
as a Master KDC , the following message is displayed:
WS5000.(Cfg).KDC> authenticate
This command is available only for a SLAVE KDC.
The present KDC is configured as MASTER.
WS5000.(Cfg).KDC>
Syntax
authenticate
Parameters
None
Example
WS5000.(Cfg).KDC> authenticate
Authenticating slave KDC with Master....
Status: Success.
WS5000.(Cfg).KDC>
mu symbol 10
: ******
: ******
Ticket Life
-----------
10 min.
8-215
CLI Command Reference