Fold & Staple Pos. Adjustment; Control Panel - Konica Minolta bizhub C353P Service Manual

7. Finisher operations
7.3 Fold & Staple Pos. Adjustment
NOTE
Make this adjustment after any of the following procedures has been performed.
• When the crease unit has been replaced.
• When a deviation occurs in the crease.
• When fold angle adjustment has been made.
7.3.1

Control panel

1. Make a print in the crease mode. (A3 size)
Exit direction
5. Display the Service Mode screen.
See P.228 of the main body service manual.
6. Select [Finisher Adjust] → [CB-FN Adjust] → [Half-Fold Pos.].
7. Press the Menu/Select key.
8. Select [A3] and press the Menu/Select key.
9. Select [Plain paper] and press the Menu/Select key.
Exit direction
30
2. Fold the print fed out along the
crease.
A
3. Check the crease for deviation (Mea-
sure width A).
Specification: 0 ± 1.5 mm
4. When the width A does not fall within
the specified value, conduct the fol-
lowing adjustment.
4511F3C505DA
• If the fold is offset as shown on the left.
10. Press
A
numeric value.
Adjustment range: 0 to -10
(1 increment 0.5 mm)
4511F3C505DA
Field Service Ver. 1.0 Oct. 2007
key and set the appropriate