Finisher Staple Misfeed; Finisher Punch Misfeed (Pk-515) - Konica Minolta bizhub C353P Service Manual

9. Jam display
9.3.6

Finisher staple misfeed

A. Detection timing
Type
Finisher staple misfeed
detection
B. Action
Staple unit
Step
1 Initial check items
2 Drive coupling section check
3 I/O check, sensor check
4 Change staple unit
5 Change FSCB
9.3.7

Finisher punch misfeed (PK-515)

A. Detection timing
Type
Finisher punch misfeed
detection
B. Action
Punch unit
Step
1 Initial check items
2 Drive coupling section check
3 I/O check, sensor check
4 Change punch unit
5 Change FSCB
80
The staple home position sensor in the staple unit is not turned ON even
after the set period of time has elapsed after the staple motor rotates for-
ward, and then the staple motor rotates backward, and the staple home
position sensor in the staple unit is turned ON within the set period of time.
Relevant electrical parts
FS control board (FSCB)
Action
Punch positioning sensors 1 and 2 are not turned ON even after the set
period of time has elapsed after the punch motor is energized.
Relevant electrical parts
FS control board (FSCB)
Action
Field Service Ver. 1.0 Oct. 2007
Description
WIRING DIAGRAM
Control signal
—
—
—
—
—
Description
WIRING DIAGRAM
Control signal
—
—
—
—
—
Location
(Electrical
component)
—
—
—
—
—
Location
(Electrical
component)
—
—
—
—
—