Konica Minolta bizhub C353P Service Manual page 180

Field Service Ver. 1.0 Oct. 2007
Order
9 System 1
10 Machine
11 System 2
12 System 1
NOTE
• After replacing the service EEPROM board, be sure to make the above listed
adjustments before the first warm-up is made.
6. Turn OFF the power switch.
7. Close the front door and turn ON the power switch.
Check to see that warm-up and image stabilization operations are completed normally.
8. Enter the Service mode again. Make individual adjustments shown in the following
table in the order listed, using the machine management list and the adjustment lists
that were output at the time of main body installation and maintenance.
Order
1 Machine
2
3
4
5 Finisher
6
7
8
9 Machine
10
11
12
13
14
15 Imaging Process
Adjustment
16
Items that require readjustment in the Service mode
Change Warm Up Time
Exhaust Fan Stop Delay
Unit Change
IU Life Setting
Items that require readjustment in the Service mode
LD adjustment
Manual Bypass Tray Adjustment
Printer Resist Loop
Fusing Temperature
CB-FN adjustment
Printer Area
Fusing Transport Speed
Printer Area
Transfer Output Fine
Adjustment
Warning Display
LD lightness balance adjust.
Fold&Staple Pos. Adjust-
ment
Finisher Check
Punch Regist Loop Size
Punch Horizontal Position
Paper Feed Direction Adj.
Centering
Centering (Duplex 2nd Side)
Leading Edge Adjustment
Leading Edge Adj.
(Duplex Side 2)
Secondary transfer adj.
Primary transfer adj.
11. Other
Ref. page
P.343
P.313
P.345
P.342
Ref. page
P.314
P.315
P.311
P.304
P.373
P.310
P.305
P.307
P.309
P.306
P.308
P.318
P.318
135