Konica Minolta bizhub C353P Service Manual page 376

Field Service Ver. 1.0 Oct. 2007
C. Detail Setting
(1) Basic Setting
Functions • Execute the primary setting.
Use • Use to change the set contents.
• Use to register the machine to the CS Remote Care center.
Setting/ 1. Call the Service Mode to the screen.
Procedure 2. Click [CS Remote Care].
3. Clicking the [Detail Setting] will display the primary setting.
<Center Setting>
• Set the center ID, Device ID, and the phone No.
• When e-mail is selected for system and all setup procedures are completed, e-mail
address of the center is displayed.
* When entering the phone number, 10-keys and keys on the screen have following
meanings.
[-] Pose
[W] Wait
[T] Tone dial : Carry out tone dialing
[P] Pulse dial : Carry out pulse dialing
[*], [#]
<Schedule (Only when the [E-Mail2] is selected)>
• Set the schedule of notification to the center.
• Up to three different notification schedules can be registered.
• Select the notification cycle from [Day], [Week], or [Month].
When selecting [Day] for the notification cycle, set the Day Frequency.
When selecting [Week] for the notification cycle, set the Week Frequency and day of
the week.
When selecting [Month], set the Month Frequency and the date of the month.
<Center Notification (Only when the [E-Mail2] is selected)>
• Select the items of data that will be sent to the center in one-way transmission
through E-Mail2.
• The following table shows each of the notification item keys and corresponding data.
[1]
[2]
[3]
[4]
[5]
[6]
NOTE
• Multiple items of data can be selected and sent at one time. However, be sure
that only EKC data cannot be sent together with other items of data.
Initial Transmission
• Clicking the Initial Transmission key will sent the information to the CS Remote Care
center to register the machine.
(Only when the modem is selected on the system Input.)
: Waits to start transmitting after dialing
: Detects the dial tone of the other end
: To be used as necessary
Sales count data
Error count data
Service count data
Life count data
Life cycle data
CSRC-System data
Device config data
History data
16. Jig Software
[7] EKC data
[8] Adjustment data
[9] Coverage data
[10] Not used
[11] Not used
[12] Not used
331