Konica Minolta bizhub C353P Service Manual page 752

Field Service Ver. 1.0 Oct. 2007
B. Jig software
<Inch area: 2 holes>
A
<Metric area: 4 holes> <Sweden: 4 holes>
A
4. Call the Service Mode to the screen.
5. Click [Finisher].
6. Click [CB-FN adjustment].
7. Click [Punch Horizontal Position].
9. Click two times [END].
10. Click [Exit] on the Service Mode screen.
11. Turn OFF the power switch, wait for 10 sec., then turn the switch ON.
12. Make a print and check the punch horizontal positions again.
<Inch area: 3 holes>
A
A
4512F3E502DA
A01GF3E507DA
7. Finisher operations
1. Set the printer into the hole punch
mode and make a 1-sided print.
2. Measure width A on the print and
check to see if the measured dimen-
sion falls within the specified range.
<Inch area: 2 holes, 3 holes>
Specifications: 9.5 ± 1.0 mm
<Metric area: 4 holes>
Specifications: 11 ± 1.0 mm
<Sweden: 4 holes>
Specifications: 11.5 ± 1.0 mm
3. If the measured width A outside the
specified range, perform the follow-
ing procedure to punch horizontal
position adjustment.
8. Set the correction value using the
[+]/[-] keys.
• To make width A wider, enter a posi-
tive value.
• To make width A narrower, enter a
negative value.
• Adjustment range: +10 max. and -10
min. (1 increment: 0.5 mm)
67