15.6 Machine Status - Konica Minolta bizhub C353P Service Manual

Field Service Ver. 1.0 Oct. 2007

15.6 Machine Status

A. HDD Format
Functions • To format the hard disk.
• The function proceeds in the order of physical format to logical format.
• If the hard disk is yet to be formatted, the malfunction code "C-D010" will appear.
Ignore this code and continue with the formatting procedure.
Use • When the hard disk is mounted.
• When the hard disk is to be initialized. (Physical format to logical format)
1. Select [Service Mode] → [Machine Status] → [HDD Format].
Adjustment
Procedure
(1) Physical Format
1. Select [Physical Format] → [Start].
2. Press the Menu/Select key to start the formatting sequence.
3. The sequence will be automatically terminated as it is completed.
4. Turn off the power switch and turn it on again more than 10 seconds after.
(2) Logical Format (only when initial is set up)
1. Select [Logical Format] → [Start].
2. Press the Menu/Select key to start the formatting sequence.
3. The sequence will be automatically terminated as it is completed.
4. Turn off the power switch and turn it on again more than 10 seconds after.
✽ Formatting the hard disk will erase all data contained in it.
B. Memory Check
Functions • To check correspondence of data written to and that read from memory through
write/read check.
Simple Check
• A check is made to see if the image data reading and writing are correctly made in a
very limited area.
• The progress of the check sequence is displayed in percentage.
Detail Check
• A check is made to see if the image data reading and writing are correctly made at
the addresses and buses in all areas.
• The progress of the check sequence is displayed in percentage.
Use • If the printed image is faulty.
1. Select [Service Mode] → [Machine Status] → [Memory Check].
Adjustment
Procedure 2. Select the desired type of check, either [Simple Check] or [Detail Check].
3. Press the Menu/Select key to start the check procedure.
4. When the check procedure is completed, the results are shown on the screen.
If the check results are NG, check the memory for connection or replace the memory
with a new one.
✽ Press the Stop key to interrupt the check sequence.
15. Service Mode
249