Management Function Choice; Coverage Rate Clear - Konica Minolta bizhub C353P Service Manual

16. Jig Software
16.18.5

Management Function Choice

• To set whether or not the Management Device (Data controller) is to be mounted.
NOTE
• It will not be displayed when the following setting is set to "ON".
[Admin. Settings]
A. Authentication Device 2
Functions • To set whether or not the authentication device 2 is installed.
Use • Set when the authentication unit (biometric type or card type) is mounted.
Biometrics : Uses biometrics (finger vein) authentication system
Card
• When selecting biometrics, set a film timeout interval.
• When selecting IC card authentication, a response timeout interval is displayed.
(The interval is unchangeable.)
Setting/ <Authentication Mode>
Procedure
16.18.6

Coverage Rate Clear

Functions • To clear the coverage rate.
Use • Use to clear the coverage rate.
Setting/ • The default setting is Unset.
Procedure
• Clicking [END] key will clear the coverage rate.
384
→ →
[Security Setting]
: Uses IC card authentication system
Card
Set
Field Service Ver. 1.0 Oct. 2007
[EnhancedSecurity]
Biometrics
"Unset"