Konica Minolta bizhub C353P Service Manual page 233

13. Utility Mode
(4) DNS Server
Functions • To set whether or not to enable the auto obtaining of the DNS server address.
• To set the priority/secondary DNS server.
Use • To enter priority/secondary DNS server.
Setting/ <Server Auto Obtain>
Procedure • The default setting is ON.
NOTE
• "ON" cannot be set when [IP Setting] is set to "Auto Setting."
<Priority/SecondaryDNS server>
• Select the corresponding key, and input the server address by IPv4 or the IPv6 for-
mat.
(5) IP Filtering
Functions • To set the IP filter (Permit).
• To set the IP filter (Deny).
Use • To set whether to allow only IP addresses that are within a specified range.
• When [ON] is set, select one from Set 1 to Set 5 and specify the range of IP
addresses to be allowed.
Setting/ <IP Filter (Permit)>
Procedure 1. Select ON or "OFF".
2. When [ON] is set, select one from Permit Set 1 to Permit Set 5 and specify the range
of IP addresses to be allowed using
3. Press the Menu/Select key.
<IP Filter (Deny)>
1. Select ON or "OFF".
2. When [ON] is set, select one from Deny Set 1 to Deny Set 5 and enter the range of
IP addresses to be denied using
3. Press the Menu/Select key.
(6) IPsec
<IPsec Setting>
Functions • To set whether to use IPsec protocol for IP network communication.
Use • When IPsec protocol is used to perform encrypted communication.
Setting/ • The default setting is OFF.
Procedure
188
"ON"
and
and
ON
Field Service Ver. 1.0 Oct. 2007
OFF
keys.
keys.
"OFF"