Konica Minolta bizhub C353P Service Manual page 589

2. Checking the controller firmware version
12. When Internet ISW is complete successfully, the control panel displays the message as
shown in the following illustration.
C. Completed or failed
(1) Firmware updated normally
1. When the Firmware is normally updated, restart the main body in auto or manual mode
to display the outcome, and press the Menu/Select key to return to the main screen.
(2) Failing to update the firmware due to the network trouble
1. When updating failed to complete due to the trouble on connecting to the network, an
error code and the message will be displayed.
2. Restart the main body in auto or manual mode, and press the Menu/Select key. It can
be used with the firmware version before conducting updating.
3. Check the settings for the network by error codes, and try updating again.
NOTE
• For error codes, refer to "Error code list for the Internet ISW".
See P.29
(3) Failing to update the firmware after downloading has started
1. Once firmware updating has started, the ROM in the main body will be deleted.
When it failed right after updating has started, restart the main body, and shift to the
standby screen to retry downloading.
2. When updating on the external panel controller, click [settings] on the standby screen,
and check the Network settings again.
Click [Download], and restart the Internet ISW.
When updating on the control panel, press the Menu/Select key on the standby screen,
and try reconnecting to the server.
NOTE
• Return to the standby screen without fail after turning the power switch OFF/ON if
the firmware is not updated.
• Firmware can be updated with the Compact flash with the power switch OFF.
D. Confirming the firmware version
1. Use the PC that has the jig software installed and enter the Service Mode.
2. Select the [Firmware Version].
3. Check if the firmware version is updated.
28
Net Client Result
Upgrade successful
Field Service Ver. 1.0 Oct. 2007
A02EF2C281DA