Staple Position Adjustment - Konica Minolta bizhub C353P Service Manual

Field Service Ver. 1.0 Oct. 2007
8.2

Staple position adjustment

NOTE
Make this adjustment after any of the following procedures has been performed.
• When the stapler has been replaced.
• When staple position is misaligned.
1-point tilted staple
D
A
B
C
1-point parallel staple
B
A
2-point staple
C
D
E
F
3. If the staple position is misaligned, adjust with the following procedure.
1. Set the staple mode and make a
print.
2. Check the staple position of the
paper.
• 1-point tilted staple
(Paper width: 216 to 297 mm)
279 to 297 mm: 45° tilt,
B5, B4S: 30° tilt
Measurement
position
A
B
C
D
• 1-point parallel staple
(Paper width: 182 to 216 mm)
Measurement
position
A
B
• 2-point staple
Measurement
position
C, F
D
E
Y = (paper width-X-11) / 2
X = A3, A4: 137
4349F3C506DA
Substitute above into the equation.
8. Mechanical adjustment
Specification
4.9 mm -3 mm to +3 mm
10.1 mm -4 mm to +4 mm
6.5 mm -3 mm to +3 mm
16.2 mm -4 mm to +4 mm
Specification
4.5 mm -3 mm to +3 mm
6 mm -4 mm to +4 mm
Specification
6 mm -4 mm to +4 mm
Y -4 mm to +4 mm
X -4 mm to +4 mm
B4, B5: 114
A4S: 190
B5S: 162
Adjustment
range
Adjustment
range
Adjustment
range
71