Trouble Code List - Konica Minolta bizhub C353P Service Manual

9. Trouble code
9.2

Trouble code list

Code
C0001 LCT communication error
C0209 LCT elevator motor failure
C0210 LCT lift failure
C0212 LCT ejection failure
C0213 LCT shift gate malfunction
38
Item
• Due to a software malfunction, etc., the time on the
watchdog timer has run out and a reset is performed.
• The elevator motor pulse sensor (PS10) cannot detect
both edges of H/L even after the set period of time has
elapsed while the elevator motor (M5) is turning back-
ward/forward (raise/lower).
• The lift-up upper sensor (PS4) is not blocked even after
the set period of time has elapsed after the paper lift-up
operation began.
• The lift-up upper sensor (PS4) is not blocked even after
the set pulse is detected by the elevator motor pulse
sensor (PS10) after the paper lift-up operation began.
• The lift-up lower sensor (PS13) is not unblocked even
after the set pulse is detected by the elevator motor
pulse sensor (PS10) after the paper lift-up operation
began.
• The lift-up upper sensor (PS4) is not blocked even after
the set period of time has elapsed after the paper lift-up
operating.
• The lift-up lower sensor (PS13) is not blocked even
after the set period of time has elapsed after the paper
lift-down operation began.
• The lift-up lower sensor (PS13) is not blocked even
after the set pulse is detected by the elevator motor
pulse sensor (PS10) after the paper lift-down operation
began.
• The lift-up upper sensor (PS4) is not unblocked even
after the set pulse is detected by the elevator motor
pulse sensor (PS10) after the paper lift-down operation
began.
• The lower over run sensor (PS7) is blocked while the
paper lift-down operating.
• The drawer cannot be determined to be out of position
even after the set period of time has elapsed after the
tray lock solenoid (SD1) is energized after the lowering
operation is finished.
• The division board position sensor (PS14) cannot be
set to L even after the set period of time has elapsed
after the operation of the division board position motor
(M3) began with the division board position sensor
(PS14) set to L.
Field Service Ver. 1.0 Oct. 2007
Description