Field Service Ver. 1.0 Oct. 2007
A. Setting items in the software switch setting
(1) ACS mode control change
Functions
• To change the 1st image transfer roller pressure/retraction operation control in ACS
mode.
Use
• When a user makes mainly monochrome prints, selecting 01 may allow avoiding the
PC drum wear-out caused by unnecessary rotation of color imaging units.
Set by Hex 00 : The color print (pressed) position is set as the default position of the
Set by Hex 01 : The monochrome print (retracted) position is set as the default posi-
Setting/
1. Select [SoftwareSWSetting].
Procedure
2. Enter "50" using
3. Select [Set by Hex] and enter "00" or "01" using
4. Press the Menu/Select key.
15.3.11
Enter Setup Date
Functions
• To register the date the main body was installed.
Use
• Upon setup.
Setting/
1. Select the key as follows.
[Service Mode] → [System Settings] → [Enter Setup Date].
Procedure
2. Enter the date (Year 4 digit → Month 2 digit → date 2 digit) using
3. Press the Menu/Select key to set the date of installation.
15.3.12
Comme System
Functions
Use
• Not used.
Setting/
Procedure
1st image transfer roller. (Default setting)
tion of the 1st image transfer roller.
and
keys.
15. Service Mode
and
keys.
and
keys.
241