System 2; Hdd; Image Controller Setting; Consumable Life Reminder - Konica Minolta bizhub C353P Service Manual

16. Jig Software

16.10 System 2

16.10.1

HDD

Functions • To configure the printer as necessary when a hard disk to mounted.
Use • Use when the hard disk is mounted.
Setting/ • The default settings are "Not Installed."
Procedure
NOTE
• When the setting has been changed, turn off the power switch and turn it on
again more than 10 seconds after.
16.10.2

Image Controller Setting

Functions • To set the type of the controller.
• [Peripheral Mode] appears when [Others] is selected.
Use • When setting up the controller.
Setting/ Image Controller Setting
Procedure • Select the controller to be used.
"Controller 0"
Controller 1
Controller 2
Controller 3
Others
Peripheral Mode
• Select the operating mode of the Scanner.
Mode 1: undefined.
Mode 2: undefined.
Mode 3: undefined.
NOTE
• When the following setting is "ON", this setting should be set to "Controller
0".
[Admin. Settings] → [Security Settings] → [EnhancedSecurity] When
[EnhancedSecurity] is set to "ON", this setting cannot be changed.
• After changing setting, make sure to turn off the power switch and turn it on
again more than 10 seconds after.
16.10.3

Consumable Life Reminder

Functions • To select whether or not to give the display of PM parts lifetime
PM parts lifetime display: An entire screen warning is given when the service life
• Applicable units:
Transfer belt unit, fusing unit, imaging unit (C, M, Y, K)
Use • Use to select not to give the display of PM parts lifetime.
Setting/ • The default setting is "Yes."
Procedure
344
Installed
: The standard controller is used.
: undefined.
: undefined.
: undefined.
: undefined.
of a specific unit has been reached, prompting the
user to replace the part.
"Yes"
Field Service Ver. 1.0 Oct. 2007
"Not Installed"
No