Lubricating The Worm Gear And Replacing The Cover Film - Konica Minolta bizhub C353P Service Manual

Hide thumbs Also See for bizhub C353P:

Table of Contents

Field Service Ver. 1.0 Oct. 2007

Lubricating the worm gear and replacing the cover film

A. Periodically lubricated parts/cycle

• Worm gear: Every 800,000 prints

B. Periodically replaced parts/cycle

• Cover film: Every 800,000 prints

C. Procedure

• Before the following lubrication and replacement work, make sure to remove

optional SD-505 and MT-502 when the finisher is equipped with these options.

1. Turn the power switch ON. Then turn the power switch OFF when the tray reaches the

lowest position during the initial operation.

2. Remove the tray unit rear cover.

A01GF2C559DA

A01GF2C560DA

3. Periodical check

3. Remove the wire saddle [1] and dis-

connect the connector [2].

4. Remove the wire saddle [1] and the

screw [2]. Remove the ground termi-

Table of Contents