16.13.10 Memory/Hdd State - Konica Minolta bizhub C353P Service Manual

Field Service Ver. 1.0 Oct. 2007
G. HDD R/W Check
Functions • To check to see if the hard disk is connected properly, and if read/write operation of
the hard disk is correctly performed.
Use • When the hard disk is mounted.
Adjustment 1. Call the Service Mode to the screen.
2. Click these keys in this order: [State Confirmation] → [Memory / HDD Adj.] → [HDD
Procedure
R/W Check].
3. Clicking the Start key will start the hard disk R/W check sequence and be terminated
automatically.
4. The check result will be displayed, [OK] or [NG].
H. HDD Format
Functions • To format the hard disk.
• The function proceeds in the order of physical format to logical format.
• If the hard disk is yet to be formatted, the malfunction code "C-D010" will appear.
Ignore this code and continue with the formatting procedure.
Use • When the hard disk is mounted.
• When the hard disk is to be initialized. (Physical format to logical format)
Adjustment 1. Call the Service Mode to the screen.
2. Click these keys in this order: [State Confirmation] → [Memory / HDD Adj.] → [HDD
Procedure
Format].
(1) Physical Format
1. Click [Physical Format].
2. Click the Start key to start the formatting sequence.
3. The sequence will be automatically terminated as it is completed.
4. Turn off the power switch and turn it on again more than 10 seconds after.
(2) Logical Format (only when initial is set up)
1. Click [Logical Format].
2. Click the Start key to start the formatting sequence.
3. The sequence will be automatically terminated as it is completed.
4. Turn off the power switch and turn it on again more than 10 seconds after.
✽ Formatting the hard disk will erase all data contained in it.

16.13.10 Memory/HDD State

Functions • To display the condition and amount of the memory and hard disk.
• To display the mounting condition of the optional encryption board (security kit SC-
503).
Use • Use to check the condition and amount of the memory and hard disk.
• Use to setup the optional security kit SC-503.
Setting/ • When the encryption board is mounted, the machine automatically recognizes it and
Procedure displays [Set].
16. Jig Software
367