Adjustment Of Clearance Between Stapler And Fd Stopper - Konica Minolta bizhub C353P Service Manual

Hide thumbs Also See for bizhub C353P:

Table of Contents

8. Mechanical adjustment

Adjustment of clearance between stapler and FD stopper

Make this adjustment after any of the following procedures has been performed.

• When stapler fails to move appropriately.

3. Remove the finisher unit.

4. Remove the finisher unit rear cover.

9J08F3C506DA

9J08F3C507DA

Field Service Ver. 1.0 Oct. 2007

1. Check the clearance between the

stapler unit [1] and the FD stopper

[2] is within the specified range.

Specification A: 2.0 mm ± 0.5 mm

2. If the value does not fall within the

specified range, make the adjust-

ment as shown below.

5. Loosen the screw [1] and move the

mounting plate [2] to adjust.

Table of Contents