Starting The Pc And The Printer - Konica Minolta bizhub C353P Service Manual

8. Service jig
8.2.2

Starting the PC and the printer

NOTE:
• The notebook PC should be started up, and the printer should be turned on before
the External Panel Controller is started up.
• If an error message appears, follow the instructions described in the message.
• Do not quit the External Panel Controller while it is being used. If it is quit, restart
the machine and the External Panel Controller.
1. Turn on the machine.
2. Press the Menu/Select key.
3. Press the key to select "Service Mode."
4. Press the Menu/Select key.
5. Input the password, and press the Menu/Select key.
6. Check that "System Settings" is selected and press the Menu/Select key.
7. Press the key to select "SoftwareSWSetting."
8. Press the Menu/Select key.
9. Select Software-SW "62" and press the Menu/Select key.
10. Press the key to select "Set by Hex."
11. Change the setting from "00" to "01" and press the Menu/Select key.
12. Press the Cancel key.
13. Turn off the machine.
14. While the printer remains OFF, turn ON the PC.
15. Check that the computer's IP address and subnet mask are set as follow:
IP address: 192.168.1.100
Subnet mask: 255.255.255.0
16. Turn ON the power switch of the printer and start External Panel Controller on the PC.
NOTE:
• It may take some time to start External Panel Controller.
NOTE:
• If the External Panel Controller does not appear in the computer screen, turn the
printer off, then on again, and then restart the External Panel Controller
50
17. Check that the External Panel Con-
A02EF2C261DA
Field Service Ver. 1.0 Oct. 2007
troller appears in the computer
screen.