Adjustment Of Clearance Between Stapler And Fd Stopper - Konica Minolta Magicolor 8650 Service Manual

6. Mechanical adjustment
6.4

Adjustment of clearance between stapler and FD stopper

NOTE
Make this adjustment after any of the following procedures has been performed.
• When stapler fails to move appropriately.
A
[2]
3. Remove the finisher unit.
See P.28
4. Remove the finisher unit rear cover.
See P.20
[2]
[1]
66
Confidential – for internal use only, do not distribute
[1]
9J08F3C506DA
9J08F3C507DA
Field Service Ver. 1.0 Oct. 2007
1. Check the clearance between the
stapler unit [1] and the FD stopper
[2] is within the specified range.
Specification A: 2.0 mm ± 0.5 mm
2. If the value does not fall within the
specified range, make the adjust-
ment as shown below.
5. Loosen the screw [1] and move the
mounting plate [2] to adjust.