Lock Cylinder - Dodge Intrepid Service Manual

23 - 16 DECKLID
LATCH STRIKER
REMOVAL
(1) Open decklid.
(2) Remove trunk liner as necessary.
(3) Remove bolts attaching latch striker (Fig. 7).
(4) Remove latch striker from vehicle.
Fig. 7 DECKLID LATCH STRIKER
1 - TRUNK LIP LATCH STRIKER
2 - TRUNK COMPARTMENT
INSTALLATION
(1) Place latch striker in position.
(2) Install bolts attaching latch striker.
(3) Verify decklid operation and alignment.
(4) Place decklid liner in position.

LOCK CYLINDER

REMOVAL
(1) Open decklid.
(2) Remove fasteners attaching decklid lining to
rear of decklid.
(3) Remove bolts attaching decklid latch to decklid
(Fig. 4), (Fig. 5) or (Fig. 6).
(4) Remove decklid latch from decklid.
(5) Disconnect power lock connector from latch
solenoid.
(6) Disconnect decklid ajar switch connector from
latch.
(7) Remove latch from vehicle.
(8) Remove decklid lock set.
(9) Remove decklid lock cylinder.
INSTALLATION
(1) Install decklid lock cylinder.
(2) Install decklid lock set.
(3) Place latch in position on vehicle.
(4) Connect decklid ajar switch connector on latch.
(5) Connect power lock connector on latch solenoid.
(6) Place decklid latch in position on decklid.
(7) Install bolts to attach decklid latch to decklid.
(8) Adjust decklid latch for proper decklid to quar-
ter panel alignment and weatherstrip sealing.
(9) Install fasteners to attach decklid lining to rear
of decklid.
(10) Verify decklid latch operation.
EMERGENCY RELEASE CABLE
REMOVAL
(1) Remove the decklid cover. (Refer to 23 - BODY/
DECKLID/HATCH/LIFTGATE/TAILGATE/COVER -
REMOVAL)
(2) Unclip cable and handle assembly (Fig. 8).
Fig. 8 EMERGENCY RELEASE CABLE
1 - RELEASE CABLE CLIP
2 - DECKLID LATCH
INSTALLATION
(1) Clip emergency release cable onto the latch.
(2) Install the decklid cover. (Refer to 23 - BODY/
DECKLID/HATCH/LIFTGATE/TAILGATE/COVER -
INSTALLATION)
LH