Dodge Intrepid Service Manual page 817

23 - 80 SEATS
HEADREST
REMOVAL
REMOVAL
(1) Lower head restraint slightly.
(2) Insert a stiff wire into the hole on the right
hand side head restraint sleeve/guide and push to
release latch (Fig. 3).
(3) At the same time, press the button on the head
restraint sleeve/guide left hand side and pull upward
to release the head restraint.
(4) Remove head restraint from seat back.
Fig. 3 HEAD RESTRAINT REMOVAL
1 - SLEEVE GUIDE
2 - BUTTON
3 - STIFF WIRE
REMOVAL - AIRBAG EQUIPPED
WARNING: DISCONNECT AND ISOLATE THE NEGA-
TIVE BATTERY CABLE
BEFORE BEGINNING ANY FRONT SEAT REMOVAL
OR INSTALLATION PROCEDURE. THIS WILL DIS-
ABLE THE AIRBAG SYSTEM. FAILURE TO DISCON-
NECT THE BATTERY
ACCIDENTAL AIRBAG DEPLOYMENT AND POSSI-
BLE PERSONAL INJURY.
WARNING: ONCE THE NEGATIVE CABLE IS DIS-
CONNECTED WAIT FOR 2 MINUTES BEFORE
REMOVING ANY AIRBAG SYSTEM COMPONENTS.
REMOTE TERMINAL
COULD RESULT
(1) Disconnect the remote negative battery cable.
(2) If fully extended, lower head restraint slightly.
(3) Insert a stiff wire into the hole on the right
hand side head restraint sleeve/guide and push to
release latch (Fig. 4).
(4) At the same time, press the button on the head
restraint sleeve/guide and pull upward to release the
head restraint.
(5) Remove head restraint from seat back.
Fig. 4 HEAD RESTRAINT REMOVAL
1 - SLEEVE GUIDE
2 - BUTTON
3 - STIFF WIRE
INSTALLATION
INSTALLATION
(1) Place head restraint in position.
(2) Push head restraint down into the lock posi-
tion.
(3) Raise head restraint to ensure it locks at the
last stop.
INSTALLATION - AIRBAG EQUIPPED
(1) Place head restraint in position.
(2) Push head restraint down into the lock posi-
IN
tion.
(3) Raise head restraint to ensure it locks at the
last stop.
(4) Connect the remote negative battery cable.
LH