To Lock The Vehicle - Dodge CHARGER 2019 Quick Reference Manual

Table of Contents

Advertisement

With a valid key fob located outside the vehicle
and within 5 ft (1.5 m) of the driver or passenger
side door handle, lift either front door handle to
unlock the door automatically.

To Lock The Vehicle

Both front door handles have buttons located on
the outside of the handle. With one of the vehicle's
key fobs located outside the vehicle and within 5 ft
(1.5 m) of the driver's or passenger front door
handle, push the door handle button to lock all
four doors and trunk.
Do NOT grab the door handle when pushing the
lock button. This could unlock the door(s).
Push The Door Handle Passive Entry Button
To Lock
Do NOT Grab The Handle When Locking
NOTE:
• If "Unlock All Doors 1st Press" is programmed,
all doors will unlock when you grab hold of the
front driver's door handle.
• If a key fob is detected in the vehicle when
locking the vehicle using the power door lock
switch, the doors will unlock and the horn will
chirp three times. On the third attempt, your
key fob can be locked inside the vehicle.
• After pushing the button, you must wait two
seconds before you can lock or unlock the
vehicle using the door handle. This is done to
allow you to check if the vehicle is locked by
pulling the door handle without the vehicle
reacting and unlocking.
• If a Keyless Enter-N-Go — Passive Entry door
handle has not been used for 72 hours, the
Keyless Enter-N-Go — Passive Entry feature for
that handle may time out. Pulling the deacti-
vated front door handle will reactivate the door
handle's Keyless Enter-N-Go — Passive Entry
feature.

Advertisement

Table of Contents
loading

Table of Contents