Dodge Intrepid Service Manual page 569

21 - 22 TRANSAXLE
42LE AUTOMATIC TRANSAXLE (Continued)
(37) Remove chain snubber (Fig. 51).
Fig. 51 Remove Chain Snubber
1 - CHAIN SNUBBER
(38) Remove transfer and output shaft sprocket
snap rings and wave washers (Fig. 52) (Fig. 53).
Fig. 52 Remove Output Shaft Sprocket Snap Ring
and Wave Washer
1 - WAVE WASHER
2 - SNAP RING
CAUTION: The chain sprockets have a slip fit onto
the shafts. Apply only a slight amount of pressure
to the chain spreader to release the chain pressure.
If chain sprockets are not spread slightly, removal
or installation will be difficult. Overspreading of the
chain sprockets will also make sprocket removal
difficult.
Fig. 53 Remove Transfer Shaft Sprocket Snap Ring
and Wave Washer
1 - TRANSFER SHAFT
2 - WAVE WASHER
3 - SNAP RING
4 - SNAP RING
5 - WAVE WASHER
(39) Install Tool 6550 and apply a light amount of
pressure to facilitate removal (Fig. 54).
Fig. 54 Install Chain Spreader
1 - OUTPUT SPROCKET
2 - SPECIAL TOOL 6550
3 - TRANSFER SPROCKET
LH