Dodge Intrepid Service Manual page 757

Dodge intrepid
Hide thumbs Also See for Intrepid:
Table of Contents

Advertisement

23 - 20
DOOR - FRONT
DOOR GLASS (Continued)
(5) Remove glass from roller channel.
(6) Raise glass upward and out of the opening at
top of door.
INSTALLATION
(1) Lower glass into opening at top of door.
(2) Place glass in position against roller channel.
(3) Insert lift plate nuts into key hole slots in
roller channel and slide channel forward to locked
position.
(4) Tighten nuts to attach regulator roller channel
to glass and lift plates.
(5) Install pull cup support bracket, water shield ,
door trim panel, and flag cover. (Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - INSTALLATION)
ADJUSTMENTS
ADJUSTMENT
(1) Remove door trim panel.(Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - REMOVAL)
(2) Remove watershield as necessary.
(3) Loosen fastener attaching scissor channel to
door panel at rear of access hole (Fig. 4).
(4) Position glass in run weatherstrips to achieve
smooth operation and proper fit.
(5) Push glass aft and apply slight downward pres-
sure on scissor channel and tighten screw.
(6) Tighten all fasteners.
(7) Install watershield.
(8) Install door trim panel.(Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - INSTALLATION)
Fig. 4 FRONT DOOR GLASS ADJUSTMENT
1 - DOOR GLASS ADJUSTMENT POINT
2 - FRONT DOOR
3 - SCISSOR CHANNEL
EXTERIOR HANDLE
REMOVAL
(1) Remove door trim panel. (Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - REMOVAL)
(2) Remove water shield as necessary.
(3) Remove door glass.
(4) Disengage clips holding latch release link and
lock link to door at latch.
(5) Disconnect links from latch.
(6) Remove screws attaching handle to door
through access hole in door inner pane (Fig. 5).
(7) Remove door handle from door.
Fig. 5 OUTSIDE FRONT DOOR HANDLE
1 - FRONT DOOR
2 - DOOR HANDLE
INSTALLATION
(1) Place door handle in position on door.
(2) Install screws attaching to handle to door.
(3) Insert links into clips on latch.
(4) Engage clips attaching latch release link and
lock link to door latch.
(5) Verify door latch handle operation.
(6) Install door glass.
(7) Install water shield.
(8) Install door trim panel. (Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - INSTALLATION)
LH

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents